COPING WITH DEATH TOTAL HANDPHONE

Here we will discuss how mobile phones are the way to overcome the sudden death total.
First we start from: BATTERY
Remove the battery on your mobile phone, our battery tests using Multytester. If it turns out the battery when testing shows that the battery is damaged, then replace with new. Edge when the time of testing the battery does not experience any problems or battery is fine then put the battery back and perform other checks.
BATTERY CONNECTORS
Checking the battery connector or brass on the phone, see if there is rust on plug and connectors Check also the flexibility of the dean of the brass pressing. Because it can also cause rupture / obstructing the flow of current from the battery.
DOING THE CONTENTS REVIEW
Once we examine all that is written on top and there's no problem, then we do charge on our cell phones, if when we do the charging and the charging indicator appears on the mobile phone screen, then it is certain that this damage is in PA.
IC PA
We remove PA IC then we turn on the phone, the outcome would turn on mobile phones. But there is no mobile phone signal, because we've removed the IC PA. If you want a signal back soon replace the PA that we open with a new PA because the old one is damaged. WHEN CHARGING INDICATOR DOES NOT APPEAR ON THE SCREEN Back in the refill process above. But while charging battery indicator does not appear on the screen and the phone still will not turn on. So we have to perform further tests using the power supply.
POWER SUPPLY
Perform the test with a power supply that you should know is to have a scale of one ampere ampere or one thousand milli amperes. Connect the existing wires on the power supply on the phone with the order, red with the positive pole, pole yellow with BSI (INFORMATION SYSTEMS BATTERY) battery connector, and a black plug with a negative pole.
NB: before turning on the power supply do not forget to direct the power supply voltage at position 0 V, because if we give the voltage is too large then the phone will be damaged. Turn on the phone and look at the needles on the ampere power supply. If the needle rises approximately 50 amperes milli amperes then the problem lies in the mobile phone software. What we must do is to be re-programmed phone or FLASH. After repeated phone in the program by using the flasher, proceed with the program NOKIA TOOL. After all are finished turn on the phone and will surely light up.