HOW TO USE AND DAMAGES locate USING POWER SUPPLY

To use the power of the phone there supplly its rules so that you feel safe and away from risk.
- Before you try to turn the power supply used with: Always use a voltage of 0 volts to power supply (to avoid over-voltage incoming negligence on the phone and cause severe damage)
- Fit the power supply cable to the phone with the order-order that is Red connect with the positive pole Yellow poles connect with BSI (Battery information systems) Black plug on the negative pole
- Once all is connected properly, turn on the power supply voltage is initially directed v 0, to 3.7 V (corresponding to the battery). With a tolerance of 0.5 Never add or menaikknan tolerance of 0.5 v.
- Then turn on the phone from off to on
- Note the needle amperes, if the needle is up about 50 amperes milli-meter. Means it can be ascertained damages lies in the software. Perform flash
- If when turning on the phone and amperage needle does not move, it means there is damage to the hardware. And do further tests on the phone.

GOOD bit of this info you can add a little insight. ...