Overcome PHONE OFF FOR WATER

With our cell phone accidentally fell into the water, then the phone we would not turn anymore, QUIET PLEASE. Here are tips to overcome all of that
.
First we must dismantle our cell phones to drain the water that still exist in our mobile phones. How to dry or dried in the sun could use a blower alone.

After our phone 100% no water, we do a test by using the power supply. Use a large-scale power supply 1 ampere or 1000 milli amps to smooth the level of sensitivity on the power supply. Connect the existing wires on the power supply to the phone we accordance with the order.
- Red connect to the positive pole,
 
- Yellow pole connect with BSI (Battery Information System)
 
do not forget before the power supply voltage is switched on to always be positioned at 0 V.
This is to anticipate the excess voltage for mobile phones, which could result in damage to the phone. After the power supply voltage of 0V turns on, point the voltage is 3.7 (corresponding to the battery) with a tolerance of 0.5
do not have to add the value of tolerance.

Turn on the phone, watch the needle on the ampere power supply, when the needle does not move at all, it means that damage to the hardwere, but when the needle rises approximately 50 amperes ampere signal damage is the softwere, should immediately take the flasher then NOKIA TOOL.

After all processes have been completed, turn on the phone. must be lit.